1 Loop Out.
Blackmagic 2110 IP Converter 4x12G PWR lets you add SMPTE-2110 IP video to 12G-SDI broadcast equipment. It features 4 independent bidirectional 12G-SDI to SMPTE-2110 IP video converters using RJ-45 10G Ethernet connections which can also provide power. Its 1RU design includes a control panel with LCD and supports HD and Ultra HD standards up to 2160p60.
All Blackmagic 2110 IP Converters support the NMOS interface specifications so all 2110 IP video devices can operate together as a large virtual router. Plus Videohub Smart Control can route sources to destinations on 2110 IP networks because it can act as an NMOS controller.
By using 10G Ethernet, Blackmagic SMPTE-2110 IP video products can be smaller, lower power, and more affordable. Plus 10G Ethernet can allow products to be remotely powered. However, when using Ultra HD above 30fps, there is not enough bandwidth for uncompressed 10-bit video. The Blackmagic IP10 codec solves this problem! It has a low latency of 8 samples, is open standard, and has no license fees. Plus it's an extremely small codec that uses very few FPGA resources, so it ensures SMPTE-2110 IP video products remain affordable!
Total SDI Inputs
5
SDI Video Inputs
4
SDI Main Program Inputs
1
Total SDI Outputs
5
SDI Video Outputs
4
SDI Main Program Outputs
1 Loop Out. SDI Rates
270Mb, 1.5G, 3G, 6G, 12G. SMPTE ST-2110 IP Video Inputs
4 x 10G Ethernet SMPTE ST-2110 IP Video Outputs
4 x 10G Ethernet Analog Audio Outputs
1 x 6.35 mm headphone socket. SDI Audio Inputs
16 Ch embedded audio on SDI input. SDI Audio Outputs
16 Ch embedded audio on SDI loop output. SMPTE ST 2110 IP Audio Inputs
16 Ch embedded audio on ST-2110 IP video via 10G Ethernet. SMPTE ST 2110 IP Audio Outputs
16 Ch embedded audio on ST-2110 IP video via 10G Ethernet. Multi Rate Support
Auto detection of SD, HD, Ultra HD and 4K.
Reclocking
Yes
Ethernet
4 x 10Gb/s RJ‑45 PoE++ connectors supporting 10/100/1000/10G BASE-T for SMPTE 2110 IP video in and out. PoE++ is power output only for powering connected PoE devices such as Blackmagic Cameras and Converters. 1 x 1Gb/s RJ‑45 connector supporting 10/100/1000 BASE-T for configuration and firmware updates. Computer Interface
1 x USB-C 3.0 for configuration and firmware updates. SDI Video Standards
SD Video Standards
525i59.94 NTSC, 625i50 PAL
HD Video Standards
720p50, 720p59.94, 720p60
1080i50, 1080i59.94, 1080i60 1080p23.98, 1080p24, 1080p25, 1080p29.97, 1080p30, 1080p47.95, 1080p48, 1080p50, 1080p59.94, 1080p60 1080PsF25, 1080PsF29.97, 1080PsF30 Ultra HD Video Standards
2160p23.98, 2160p24, 2160p25, 2160p29.97, 2160p30, 2160p47.95, 2160p48, 2160p50, 2160p59.94, 2160p60
4K Video Standards
4Kp23.98 DCI, 4Kp24 DCI, 4Kp25 DCI, 4Kp29.97 DCI, 4Kp30 DCI, 4Kp47.95 DCI, 4Kp48 DCI, 4Kp50 DCI, 4Kp59.94 DCI and 4Kp60 DCI.
SDI Compliance
SDI Video Rates
SDI video connections are switchable between standard definition, 720p, 1080i, 1080p, 2K DCI, Ultra HD and 4K DCI. SDI Color Precision
4:2:2 SDI Color Space
YUV
SDI Auto Switching
Automatically detects SD, HD, 2K DCI, Ultra HD and 4K DCI. Level A and B is automatically detected on 3G-SDI input and user selecspecs on 3G-SDI output.
IP Video Compliance
SMPTE 2110-20 (Uncompressed Video)
IGMP v2
SMPTE 2110-21 (Traffic Shaping)
Sender: Narrow
Receiver: Narrow, Wide Synchronous, Asynchronous SMPTE 2110-30 (PCM)
Audio Conformance level: Level C SMPTE 2110-40 (Ancillary Data)
Full access to entire SMPTE ancillary data stream. Includes RP 188/SMPTE 12M-2, closed captioning and HDR static metadata.
Codec
Blackmagic IP10 codec used when converting 12G-SDI rates to 10G 2110 IP video.
Precision Time Protocol
IEEE 1588-2008 (PTP v2)
ST 2059-1 ST 2059-2 NMOS IS-04 Discovery and Registration
v1.3.2 Peer-to-peer via mDNS/DNS-SD NMOS IS-05 Connection Management
v1.1.2 NMOS BCP-002-01
Natural Grouping
NMOS BCP-004-01
Receiver capabilities
Audio
Front panel audio monitor speaker with speaker control button, plus 6.35 mm headphone socket.
Control
Built-in Control Panel
12-button control panel, 2.2-inch color display, and spin knob for setup and menu settings. Operating Systems
Mac 13.0 Ventura Mac 14.0 Sonoma or later. Windows 10 and 11. Power Supply
2 x Internal 100 ‑ 240V AC 50/60Hz with IEC C14 mains input.
Physical Installation
1 rack unit.
Environmental Specifications
Operating Temperature
5° to 40° C (41° to 104° F)
Storage Temperature
-20° to 45° C (-4° to 113° F)
Relative Humidity
0% to 90% non‑condensing What's Included
Blackmagic 2110 IP Converter 4x12G PWR Welcome wallet with QR code for software download Warranty
12 Month Limited Manufacturer’s Warranty. |