Teradek Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V Mount)-Main

Teradek Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V Mount)

This product has been discontinued.

We have discontinued this product permanently. Please find alternative products from below section.

Teradek Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V Mount)

  • Amount of Receiver Included: 2
  • Mount Type: V Mount
  • Transmission Range: 1000ft
  • Input / Output: 3G-SDI & HDMI
  • Resolution / Frame Rate: 1080p60
  • Latency: < 0.001 seconds
  • Size (TX): 24 x 66 x 102mm
  • Multicast: Up to 4 Rx
  • Weight TX / RX: 238g / 380g
  • Supports real-time standards and cross conversion from TX to RX
  • Transmitters 20% smaller in size than previous series

Lighter, smaller, and more rugged as well as affordable and finer capability are the best description for the Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V-Mount) from Teradek. This impressive deluxe kit is a collection of the new Bolt Pro 1000 Transmitter and Receiver set with the antenna array and SKB utility case. Users are provided with 2 receivers and with V-Mount type.

The attractive refinements from this Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V-Mount) are excellent connection times on the wireless signals transmission side and the new firmware to make the system performs the most potential operation. Bolt also comes with the manual frequency control so users can cautiously arrange the wireless workflow wherever the shooting location will be. What’s more, the improvement for the wireless technology side performs to restore the wireless link shortly, as such users are given the best wireless connection at any time this device will be used shortly after being switched off.

Obviously, this Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V-Mount) comes with the new look: smaller in size and design changing. Therefore, it makes this device becomes more portable. In addition, there are extra features: dual inputs/outputs, 3D LUTs, multicast capable, manual frequency selection and USB 3.0 GRAB Engine.

Specs

Bolt 1000 Transmitter

Video Input

1 x 75 Ohm BNC

1 x Type A receptacle HDMI

 

Video Output

1 x 75 Ohm BNC(Loop-out)

 

Video Delay (Tx to Rx)

<0.001sec (when no video format conversion is enabled)

 

Colour Sampling

Y:Cb:Cr = 4:2:2, 8-bit for SDI (10-bit with no format conversion and FPGA v.1.1.0 or later); RGB 4:4:4 (HDMI out, 8-bit color)

 

Supported Resolutions

1080p60/59.94/50/30/29.97/25/24/23.98

1080psf30/29.97/25/24/23.98

1080i60/59.94/50

720p60/59.94/50

480p59.94/576p50 (via HDMI ports only)

480i(NTSC)/576i(PAL)

 

Wireless

Up to 1000ft line of sight

 

Non-DFS Frequencies

US: 5.19 ~ 5.23 GHz and 5.755 ~ 5.795 GHz

EU & JP: 5.19 ~ 5.23 GHZ

 

DFS Frequencies

US: 5.27 ~ 5.55 GHz and 5.67 GHz

EU & JP: 5.27 ~ 5.67 GHz

 

RF Power

19 dbm EIRP(with two 5dbi TX antennas)

Noise Rejection: Can coexist with WiFi and 5GHz cordless phones

 

Audio

Format Support: 48kHz 24-bit PCM

 

Physical

Dimensions: 0.95"x2.6"x4.47"(24mmx66mmx101.5mm)

Weight: 8oz(226g)

Material: Milled Aluminum

 

Mountability

Multiple mounting options with 1/4" hole

Multiple mounting options with 4-40 holes

 

Power

2-Pin Lemo 7-28 VDC

No Internal Battery

 

Consumption

7.5 Watts

 

Bolt 1000 Receiver

Video Output

1 x USB 3.0 micro B receptacle

1 x 75 Ohm BNC

1 x Type A receptacle HDMI

 

Video Delay (Tx to Rx)

<0.001sec (when no video format conversion is enabled)

Colour Sampling: Y:Cb:Cr = 4:2:2, 8-bit for SDI (10-bit with no format conversion and FPGA v.1.1.0 or later); RGB 4:4:4 (HDMI out, 8-bit color)

 

Supported Resolutions

1080p60/59.94/50/30/29.97/25/24/23.98

1080psf30/29.97/25/24/23.98

1080i60/59.94/50

720p60/59.94/50

480p59.94/576p50 (via HDMI ports only)

480i(NTSC)/576i(PAL)

 

Wireless

Up to 1000ft line of sight

 

Non-DFS Frequencies

US: 5.19 ~ 5.23 GHz and 5.755 ~ 5.795 GHz

EU & JP: 5.19 ~ 5.23 GHz

 

DFS Frequencies

US: 5.27 ~ 5.55 GHz and 5.67 GHz

EU & JP: 5.27 ~ 5.67 GHz

 

RF Power

17dbm EIRP(with one 2dbi TX antenna)

 

Noise Rejection

Can coexist with WiFi and 5GHz cordless phones

 

Audio

Format Support: 48kHz 24-bit PCM /li>

 

Physical

Dimensions: 5.5” x 3.5” x 1.0”(139mm x 88.5mm x 25 mm)

Weight: 13.3oz(376g)

 

Mountability

Multiple mounting options with 4-40 holes

Multiple mounting options with 1/4" hole

 

Interfaces

OLED display with joystick navigation buttons

 

Power

2-Pin Lemo 7-28 VDC

No Internal Battery

 

Consumption

8.5 Watts

 

Package Weight

5 lbs

 

INCLUDED

1 x Bolt Pro 1000 TX SDI/HDMI

1 x Bolt RX Single (AB or V) Mount Battery Plate 14.4V

1 x Panel Antenna Array 5GHz 3x16dBi 2x 14dBi Black

1-2 (depending on option chosen) x Bolt Pro 1000 RX SDI/HDMI

1 x 1/4 20" Thumb Screw Plastic Head 2 inch length

 

5 x N-Male to RP-SMA 12 inch cables (for use with Bolt Rx Only)

1 x 1/4 20 Thumb Screw Plastic Head 3/8 inch length

1 x 1/4 20" Thumb Screw (1.25 inch)

1 x 1/4-20 Screw Phil Pan Mach Black 3/8 inch

1 x 3/8" Light stand Adapter

 

1 x 1/2 20" Lightstand Adapter

1 x PSU 2-Pin Lemo 18W

1 x 2pin Lemo to PowerTap - 18 inch Cable

1 x USB 3.0 SuperSpeed Cable (A to Micro, 3ft)

1 x 2pin Lemo to PowerTap - 11 inch Cable

 

1 x Hot Shoe Adapter

2-3 x (2 for 1 Rx, 3 for 2 Rx) HDMI Cables (Type A to Type A)

2-3 x (2 for 1 Rx, 3 for 2 Rx) SDI Cables (BNC to BNC)

2 x Antenna 2dBi WiFi 2.4/5.8 GHz

 

5 x Antenna 2dBi WiFi 5.8GHz

1 x SKB Waterproof Utility Case (22 x 17 x 8 inches)

1-Year Warranty on Bolt Pro Units

Write Your Own Review
You're reviewing:Teradek Bolt 1000 Deluxe Kit SDI/HDMI Wireless Video Transceiver Set (2 Receiver + V Mount)
Your Rating
Customer Questions
No Questions
Please, mind that only logged in users can submit questions